Add some flair to your space with this simple-to-follow DIY project. This DIY jewellery organizer is the perfect solution to hold and display your favourite pieces of jewellery.
There are 9 steps to completing this project:
On a 24 x 48-inch piece of plywood, measure 6 inches for the width and 23 3/8 inches for the length and cut into two pieces. For ease, we will name these two boards: board A and board B.
Using the same 24 x 48-inch piece of plywood, measure 2 ½ inches for the width and 23 3/8 inches for the length and cut a third piece (board C) which will be attached to board B as a shelf.
Sand the edges of the three boards.
Using ¼ x 48-inch dowels, cut three pieces at 23 3/8 inches and sand the cut edges.
Stain all pieces (boards and dowels) and leave to dry.
Glue board B and board C together and clamp them tightly, making sure to remove any excess glue with a damp cloth. Leave to dry.
Secure board B and C together with a couple of 1 1/2-inch plated finishing nails.
Add your ¾-inch cup hooks to the boards.
Board A: Measure 1 inch from the top and side of each corner and insert two hooks. From underneath the board, measure 1 inch from each corner and side and insert two hooks.
Board B: From underneath, measure 1 inch from each corner and side and insert two hooks. In between the hooks, fill the empty space by inserting 12 more hooks, leaving a gap of 1 ½ inches between each one.
Board C: From underneath, measure 1 inch from the top and side of each corner and insert two hooks.
Add two dowels to board A and one dowel to board B.
Add two sawtooth hangers to the back of board A.
Add two sawtooth hangers to the back of board B.
That’s it, you’re done!
