Step 1 Gather Materials
Gather materials.
DIY Wood Crate Charging Station
Your device cords can get messy. Keep them tidy with this DIY charging station. A tidy and stylish solution for charging all your electronic devices.
Skill Level: Beginner
Time:
-
There are 10 steps to completing this project:
-
-
-
-
Step 2 Measure Crate Opening
Measure the opening of your crate from the inside and then subtract ¼’ from each side.
-
Step 3 Mark and Cut
Mark measurements on your plywood and cut.
-
Step 4 Drill Holes
Drill 1” holes in the front middle and back middle of the plywood, as well as in the back of the crate.
-
Step 5 Measure Crate Depth
Measure the depth of your crate and subtract two inches.
-
Step 6 Cut Nailing Strip
Mark measurements on your nailing strip and cut into 4 equal pieces.
-
Step 7 Glue Nailing Strips
Using wood glue, secure the 4 pieces of nailing strips to the corners of your crate. Let dry.
-
Step 8 Thread Power Bar and Cables in Crate
Thread power bar through the back hole in crate. Plug in your device chargers and thread cables through holes in plywood.
-
Step 9 Place Plywood on Top of Nail Strips
Place plywood on top of nail strips.
-
Step 10 Enjoy!
Plug in your devices and enjoy!
